|
|
#1
03-05-2010, 01:54 PM
|
|||
|
|||
header install
just had to order an oem header to put on my 07 1krr and was wondering what procedures were required after the install?
__________________
2000 Kawasaki 250 ninja (STOLEN) 2002 Kawasaki ZX6R (SOLD) 2000 Yamaha R1 (SOLD) 2007 Honda CBR1000RR 
|
|
#2
03-05-2010, 06:22 PM
|
||||
|
||||
|
I don't think there's anything special you need to do for a stock header. I bought my 07rr new and didn't do anything other than the normal break in for the motor. I'm sure ur going to have some burn off from chemicals and manufacturing dust smoking for a lil bit. I would assume just ride around on it for a little bit and check the bolts
|
|
#4
03-05-2010, 08:32 PM
|
||||
|
||||
|
Their just pipes, but yeah torque the bolts then ride it around for about 10 or so miles and re torque the bolts when it cools back down. Or put lock washers on that shit.
__________________
<~OTL~> "12 O' Clock" 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
